craft companion’s edgeables with cuttlebug
i’m trying the dies with cuttlebug and they won’t cut the center part of die. i also added an extra piece of cardstock for more pressure. no luck. my “sandwich” consists of A plate, mat,B plate,die attached to cardstock,extra cardstock , B plate. any help would be appreciated.
OK it worked 95%. just had tomake one small snip. i use the cardboard the die was onand wax paper as extra shims. a bit of a pain but i am stubborn too. lol. thanks again for tip.
thank u Wilddietta, i will try them.
Have you tried the green rubber pad that comes with some of Anna’s die cut kits? Try some wax paper in between the die cut and paper. I have had trouble with some of my die cuts too. I made a “shim card” out of some cardboard and I put it in the sandwich. Sometimes that helps too. Hope one of these ideas works for you. I learn these tricks watching YouTube videos.
thank u Seanchai for replying. I did try C plate, same thing , not enough pressure. I wonder what Sara Davies did. I bet it was with her Gemini.
I wish I could help, but I don’t know anything about it.
Posted in Crafts & Sewing
04.30.16 10:03 PM